Commissioning - Conrad Electronic 75 15 09 Operating Instructions Manual

• Connect the white cinch plug of the adapter cable with the display device's audio
input.
• Connect the yellow cinch plug of the adapter cable with the display device's
video input.
• Screw the aerial onto the receiver.
• Connect the low-voltage plug of the supplied plug-in power supply with the "DC
IN 5 V" (13) power connection on your wireless receiver.
• Plug the plug-in power unit into a suitable mains socket.
To avoid distortion or mismatching that could damage the appli-
ance, the audio connecting plug (white) may only be connected to
an audio cinch input.
The video connecting plug (yellow) may only be connected to a
video cinch input.
If you are not clear about the correct connection, contact our
technical support or another specialist.
To extend the audio and video signal, only use suitably shielded
cinch cables. The use of other cables may cause faults. Keep the
length of the cable as short as possible.
6. Initial operation
• Insert the two plug-in power units of the wireless system into the mains sockets.
• Turn your display device on and set the respective channel to enable the display
function.
24