Assembling The Radio Camera; Connecting The Radio Camera; Connecting The Radio Receiver - Conrad Electronic 75 15 09 Operating Instructions Manual

5.1 Installation of the radio camera
All the connecting cables must not be bent or squeezed. This can
result on malfunctions, short circuits and defects in the device.
Make sure that cables are not damaged when drilling or bolting in
place. Make sure that the plug and socket of the connection cable
of the camera are not exposed to humidity. Plugs and sockets
may only be used indoors. The cable from the camera must thus
(for installation in outdoor areas or in damp rooms) be placed so
it is led into a dry room.
• Seek out a suitable mounting location for the camera
• There are 3 installation holes on the support (7). Draw these (e.g. with a pencil)
on the wall.
• Attach the support to the wall using suitable installation material
• Screw the camera onto the support (7).
• If you have not done so already, screw the provided aerial (1) onto the camera.
• Adjust the camera to the desired position.
• Tighten the locking screw on the support (7).
Do not point the camera directly toward a source of bright sun-
light or toward strong or indirect illumination as this may lead to
overexposure and a fuzzy picture.

5.2 Connecting the radio camera

• Connect the low voltage plug of the supplied plug-in power supply with the "DC
IN 5 V" (8) power connection on your wireless camera.
• Plug the plug-in power unit into a suitable mains socket.

5.3 Connecting the radio receiver

• At the output "A/V out" (12), connect the 3.5 mm jack plug of the provided
audio/video cable (= adapter cable 3.5 mm jack to 2 x cinch).
23