Configuring The Start Key Of The 3Rw5 Hmi High Feature - Siemens SIRIUS 3RW55 Equipment Manual

Parameters
Parameters
F1 - Local/Remote
F2 - Reset
Edit function favorites
Display depends on the current setting
1)
Not available with the 3RW55 Failsafe soft starter
2)
3) Not available for Ex operation
3RW5 HMI High Feature from firmware version V3.0
4)
Result
You have reassigned the function favorites F3 ... F9.
6.9

Configuring the start key of the 3RW5 HMI High Feature

Operating principle
You can assign up to 4 different start functions to the start key of the 3RW5 HMI High Feature.
In the factory setting, the start function "Motor CW" is assigned to the start key. If the start key is
configured and then pressed, this opens the parameterized start functions in a pop-up window.
They can then be selected by means of the navigation keys and activated with the "OK" key.
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006
6.9 Configuring the start key of the 3RW5 HMI High Feature
1)
F3 ... F9
Description
Changes master control
Acknowledges faults
Menu for Function selection F1 ... F9:
• No function
• Motor CCW - creep speed
• Motor CCW
• Motor CW - creep speed
• Motor CW
• Start pump cleaning
• Select parameter set 3)
• Alternative stopping mode
• Quick-stop
• Save logbooks to micro SD card
• Save parameter settings to micro SD card
• Creep speed 2)
• Emergency start
3)
• Emergency run
2), 3), 4)
• Local/Remote (permanent setting F1)
• Reset (permanent setting F2)
Parameter assignment
2)
2)
119