Section A - New Construction - Attaching To Joist - Hunter 43044-01 Installation Manual

Section A - New Construction - attaching to joist

A1
Pop out a wiring access slug.
A2
5/8
1/2
Position the correct depth mark at the bottom edge of the
joist based upon the the thickness of your sheetrock.
A4
Run the power supply wire through the strain relief, leaving
3" between the end of the wire and the strain relief. Tighten
the strain relief around the wire.
OR
A3
5/8
1/2
A5
3"
Install the wiring and the strain relief into the wiring access
6
43044-01 03/05/2008
Drive mounting screws (supplied) into joist or framing.
hole you made earlier.