Short Message Service (Sms) - Leica ComGate10 User Manual

5.4
Description
Valid commands
Example of an SMS
response to a
status request
Leica ComGate10, Technical Data

Short Message Service (SMS)

Use SMS to control the wireless router of the ComGate10. Send an SMS to the phone
number of the SIM card in the ComGate10.
Command Description
status An SMS with the following information is returned:
• Signal strength
• Connection state (up/down)
• Current IP address of the mobile (ppp) interface
• Status digital I/O
reboot The wireless router is restarted. The initialisation is finished when
the "Status" LED on the front panel of the wireless router has
stopped blinking.
output Example: output 2 rec
{channel}
To switch the digital output.
{action}
Possible channel numbers:
• {1}
• {2}
Possible actions:
• {on}
To close the circuit breaker of the digital output.
• {off}
To open the circuit breaker of the digital output.
• {rec}
Stands for recycle power.
To open/close the circuit breaker for DO2 and close/open the
circuit breaker for DO1.
This can be used to reboot any sensor which is connected to the
ComGate10.
SMS response
System ComGate10
(00112Bxxxxxx)
Communication WAN1: LAN2 is disabled (0.0.0.0) No connection established by
state
Communication WAN2: WWAN1 is up
state
(123.111.123.111,
Mobile1, HSPA, −91 dBm)
State digital I/O DIO: IN1=off, IN2=off,
OUT1=off, OUT2=on
Description
Name of the system
Serial number of ComGate10
WAN interface
Connection to the Internet by the
mobile interface
(Assigned IP address, signal
quality, strength)
State of every available digital I/O
42