Leica ComGate10 User Manual page 37

Specification of USB
port
Specification of
LAN/WAN port
Specification of
RS232 port
Leica ComGate10, Technical Data
Port Panel
Top
Top
Top
Top
Top
Top
Feature
Speed
Current
Feature
Isolation
Speed
Mode
Crossover
Feature
Protocol
Baud rate
Data bits
Parity
Stop bits
Software flow control
Hardware flow control
Description
Earth protection connector. Connected to the ground
of the power supply V GND. If used, connect a yellow-
green marked cable with at least 6 mm
Avoid corrosion and protect the screws against loos-
ening.
Power supply 12–48 V DC (Pin 1/Pin 2). Additional
power supply (redundancy) 12–48 V DC (Pin 3/Pin 4).
Non-isolated serial RS232 interface (Pin 5 to Pin 7).
Can be used for serial device server or other serial
based communication applications.
Galvanic isolated digital outputs (Pin 8 to Pin 11).
Default position of circuit breaker:
• DO1: Open
• DO2: Closed
Galvanic isolated digital inputs (Pin 12 to Pin 15).
• To reboot press at least 3 s.
• To reset to factory settings press at least 35 s.

The start of the factory reset is confirmed by
all LEDs lighting up for a second. The button
can be released then again.
Specification
Low, Full and Hi-Speed
Max. 500 mA
Specification
1500 Vrms
10/100 Mbps
Half- and Full-Duplex
Automatic MDI/MDI-X
Specification
3-wire RS-232 (TXD, RXD, GND)
300, 1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200
7 bit, 8 bit
none, odd, even
1, 2
None, XON/XOFF
None
2
copper area.
37