Foreword 1 General Information 1.1 Ordering Codes and Accessories 2 Getting Started 2.1 Parts List 2.2 Preparation 3 Appendix 3.1 Safety 3.2 Certifications and Compliances 3.3 Warranty 3.4 Copyright and Exclusion of Reliability 3.5 Thorlabs Worldwide Contacts and WEEE policy...
Optional Accessories · PDA-C-72 DC power supply cable to PDA8A2: This cable has a connector on one end and open wires at the other. The pin-out of the PDA8A2 DC power jack is shown in the appendix of the full manual.
· Switch on the power supply. · Attach a 50 W coaxial cable (i.e. RG-58U) to the output of the PDA8A2. When running cable lengths longer than 12” we recommend terminating the opposite end of the coax with a 50 W resistor (Thorlabs p/n T4119) for maximum performance.
Thorlabs GmbH. Attention Prior to applying power to the PDA8A2, make sure that the protective conductor of the 3 con- ductor mains power cord is correctly connected to the protective earth ground contact of the...
For warranty repairs or service the unit must be sent back to Thorlabs GmbH. The customer will carry the shipping costs to Thorlabs GmbH, in case of warranty repairs Thorlabs GmbH will carry the shipping costs back to the customer.
Contact Thorlabs for more information. Waste treat- ment is your own responsibility. “End of life” units must be returned to Thorlabs or handed to a company specializing in waste recovery. Do not dispose of the unit in a litter bin or at a public waste disposal site.
Need help?
Do you have a question about the PDA8A2 and is the answer not in the manual?
Questions and answers