Expanding Tool - Rehau RAUTOOL A-LIGHT2 Product Instructions

RAUTOOL A-LIGHT2
TOOL PREPARATION
– Make sure that whenever the jaw sets are changed the pins are
completely and safely locked in place.
– Before changing the jaw sets, the battery must definitely be
removed from the tool (inadvertent activation).
– Before each use, check the jaw sets, expander bits, expander sets
and the tool for damage or visible wear. Damaged tools must no
longer be used and should immediately be sent to a REHAU
representative for repair.

Expanding Tool

Expander
When screwing on expander
heads, open expander completely
(> 90° position). Always screw
expander heads on fully. Use ex-
pander heads that conform to the
pipe dimensions (for example, 25
x 2.3 mm).
Always insert the expanding tool
into the pipe up to the stop.
– When inserting the expander bit, click it completely into the com-
pression jaws.
– The entire surface of the receiving groove of the bit must lie in the
compression jaws.
Before activating the tool, check to make sure that the seating and
clamping action of the bit in the jaws is correct (to avoid falling out).
If necessary, increase the clamping action through short activation of
the tool's operating switch.
Expander Bit
When inserting the expander
bit for hydraulic expanding, fully
click the correspondingly sized
expander bit into the respective
compression jaws and check for
fit (clamping).
9