Rehau RAUTOOL A-LIGHT2 Product Instructions page 12

4. Insert fitting into pipe up to the stop. After a brief period, the fitting
will sit tightly in the pipe (memory effect).
Note: All sealing ribs must be covered. Until the memory effect has
set in completely, the fitting can fall out of the pipe. Make sure to seat
the fitting in level position.
5. Fully insert the joint into the clamping tool.
Note:
Do not tilt. Tool must be applied over full surface and at right
angles.
6. Start compression process by activating the operating switch and
press in the compression-sleeve up to the fitting collar.
CAUTION!
Do not touch moving parts. Touching moving parts
could cause fingers to become trapped.
The compression process can be interrupted at any time by releasing
the operating switch.
7. The tool comes equipped with a semi-automatic release valve. If the
tool is moved to its final position for a prolonged period or used again
after arriving at its final position, the tool will automatically return to
its starting position. The tool can be manually returned to its starting
position if the release valve is activated using black button opposite
the operating switch.
8. Completed compression-sleeve joint.
12
ZGT_07705
ZGT_07706
ZGT_07705
ZGT_07706