Assembly Procedure - Rehau RAUTOOL A-LIGHT2 Product Instructions

RAUTOOL A-LIGHT2

ASSEMBLY PROCEDURE

1. Using pipe cutters, cut pipe to required length at right angles and
without leaving burrs.
Note: Keep your hand at a safe distance from the tool. Do not use
saws, or similar.
2. Slide compression-sleeve onto pipe. With metal compression
sleeves, the inside taper must point toward the joint.
Note:
To avoid damage to the tool, do not tilt the pipe when expand-
ing. Do not expand under bending stress.
3a. Expansion using expanders:
Expand pipe, rotate 30° and repeat. The mininum distance between
expander head and compression-sleeve must be two compression-
sleeve lengths.
3b. Expansion using expander bit
Expand pipe, rotate 30° and repeat. The minimum distance between
expander head and compression sleeve must be two compression-
sleeve lengths.
11