Technical Information - IKEA ENASTAENDE Manual

ENGLISH
Problem and alarm code
The salt indicator continues
to stay on after replenish-
ment of the salt container.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa-
ter drops on glasses and
dishes.
The dishes are wet.
Refer to "Hints and tips" for
other possible causes.

Technical information

Dimensions
Electrical connection
• If after 3 or 4 programmes, the salt indicator continues to
stay on, contact the service.
This can occur when you are using salt that needs more
time to dissolve.
There in no unwanted effect on the performance of the
appliance.
• The release quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
• The programme does not have a drying phase or has
a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try a
different brand or activate the rinse aid dispenser and
use rinse aid and multi-tablets together.
Width / height / depth
(mm)
Voltage (V)
1)
Frequency (Hz)
Possible solution
For alarm codes not described in the table,
contact an Authorised Service Centre.
Possible solution
596 / 818-898 / 550
220 - 240
50
20