Table of Contents
Advertisement
8. W
ARNINGS AND
8.1 G
ENERAL
1. The SR Radar is an electronic radiating product. As such it is not recommended for
installation with densely populated areas, or in the vicinity of such areas. Magos
recommends installation at remote, un-populated, outdoor sites only. In addition avoid
prolonged un-necessary human contact with the radar and as a rule it is recommended that
the installation with maintain a 3m radius safety distance from the sensor.
2. The SR Radar is not intended for direct connection to the AC power network. When using
power supplies/converters with the radar that are connected to a local or national AC power
network make sure they are properly isolated and are in full compliance with your local
regulations. In any event Magos will not liable to any damage caused to the product or any
interference caused to the power network resulting from a faulty/in-appropriate power
supply.
3. Mechanical installation of the SR500 is not within the scope of responsibility of Magos.
Magos is not liable to any damage incurred to the customer and/or to a third party due to
faulty installation (loose bolting/weak brackets etc).
4. The SR Radar should be serviced only by a person qualified by Magos.
8.2 FCC C
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in residential installations. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio and television reception.
However, there is no guarantee that interference will not occur in a particular installation. If
this device does cause such interference, which can be verified by turning the device off and
on, the user is encouraged to eliminate the interference by one or more of the following
measures:
Re-orient or re-locate the receiving antenna.
●
Increase the distance between the device and the receiver.
●
Connect the device to an outlet on a circuit different from the one that supplies power to the
●
receiver.
Consult the dealer or an experienced radio/TV technician.
●
WARNING! Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Page 26
D
ISCLAIMERS
S
OMPLIANCE
TATEMENT
© Copyright 2017, Magos Systems. All Rights Reserved
Advertisement
Table of Contents
