Table of Contents
Advertisement
TamperSw – Internal tamper switch has been activated. This means that the radar's front
●
cover (Radome) has been physically removed. This test is continuous.
Note I – This test is only support in specific HW models that include the Tamper Switch.
Contact Magos support to find out whether your unit includes this feature.
Note II – Once tamper switch is set it can only be cleared by an authorized Magos technician.
7.3 H
ANDLING
In case of Jamming report – try to find out if there are any radio emitting devices in the
vicinity of the radar (wireless communication equipment, nearby radars, etc.). Use the angle
measurement report to narrow down the emitting source possible locations.
In case of temperature – the radar is designed to operate in extreme temperature conditions
from -40° up to +85° Celsius. If installed in a harsh environment that exceeds these limits try
to control temperature by shading/adding circulation (in case of over-heating) or adding an
external heat source (even a lamp) in case of extremely low temperatures.
In case of tamper SW – this indicates that radar has been physically tampered. Even if
tamper occurred due to an innocent mistake, once the Radome has been opened the unit
must be inspected by Magos personnel or an authorized technician to ensure that no lasting
damage has occurred.
In case of failure in all other tests the unit must be inspected by Magos personnel or an
authorized technician in order to locate the HW fault and repair it.
Page 25
F
BIT R
AILED
EPORTS
© Copyright 2017, Magos Systems. All Rights Reserved
Advertisement
Table of Contents
