Table of Contents
Advertisement
6. C
OMMUNICATION
The SR sensor supports standard ethernet interface (standart 100Mbps). The product
label contains it's unique MAC address. When interfacing Magos propritery MASS C&C
software consult with the MASS user manual for more details on sersor interface and
ICD.
Otherwise please contact Magos at
C&C software, sensor setup etc.
6.1 R
ADAR
The "Radar Manager" software tool is a simple configuration tool for swift and easy network
configuration of the SR Radar. This tool doesn't require installation and can be downloaded
from (www.magossystems.com/download/). If you encounter problems during download you
may contact Magos support team (support@magosys.com) for assistance.
This section contains instructions on how to use the "Radar Manager" tool to detect radars
connected to your local network and to assign them with user defined IP addresses. This
initial step is crucial for proper communications with the radars via C&C/PSIM software
(either Magos MASS or any other software based on Magos SDK).
Figure 14 depicts the Radar Manager main screen as it is shown when first running the tool.
The play/stop buttons on the top left of the screen can start/stop the tool from scanning
network messages.
While running the tool scans for specific broadcast messages periodically sent by each of
the operational SR radars that are connected to the same local network as the PC running
the Radar Manager.
As seen in Figure 14 the main screen lists the radars it detected in a table. Each device
occupies one row in the table with the following columns:
MAC – device specific and unique MAC address
●
IP – current IP address assigned to the SR50
●
Model – Device model and firmware version
●
Last Update – the time and data of the last message broadcast by the device.
●
Page 21
I
NTERFACE
support@magosys.com
M
ANAGER
for information on supported
© Copyright 2017, Magos Systems. All Rights Reserved
Advertisement
Table of Contents
