Table of Contents
Advertisement
Clear Address Book and Registered Data
This function is used to clear the items indicated below, which cannot be
cleared or initialized using "Clear All Memory" (page 19 of this manual) or
"Settings (Administrator)" > "System Control" > "Reset Settings" >
"Restore Factory Defaults".
The following types of data can be cleared.
User Information
Contacts/Group/Program (address only)/Relay Broadcast Memory Box/
Forward Information
Polling Memory/Confidential Memory Box
Sender Data
Allow/Reject Reception Setting Data (including polling passcode
*1,*3
number)
Forward Information
* 1. The name may vary depending on the options that are installed.
* 2. Can only be selected when the fax function is enabled.
* 3. Can be selected when either the fax function or the Internet fax function is in
use. ("including polling passcode number" is displayed only when the fax
function is enabled.)
* 4. Select this when you only wish to erase stored forwarding information.
1
Select the checkbox of each item that you wish to clear.
2
Tap the [Clear] key.
A confirmation message will appear.
3
Tap the [OK] key.
The selected data is cleared.
(Operation during clearing is the same as "Clear All Memory" (page 19 of
this manual).)
In the event that the data security kit or a machine with the data security
kit installed will be disposed of or ownership will change, the
administrator should be sure to use this function to clear all items. When
executing the function, the administrator should not leave the machine
until it has been verified that data clearing has been completed.
*1
*4
21
Security settings
*2
Advertisement
Table of Contents
