Mounting Rec Twinpeak Series Panels With Continous Rails Parallel To Long Side Of The Panel; Fig. : Clamping Of Rec Twinpeak Series Panels With Rails Parallel To Long Side Of The Panel - REC TwinPeak 4 Series Installation Manual

MOUNTING REC TWINPEAK SERIES PANELS WITH CONTINOUS RAILS PARALLEL TO LONG SIDE OF THE PANEL

A continous rail (or other support structure) spans the complete underside of the panel.

Fig. : Clamping of REC TwinPeak Series panels with rails parallel to long side of the panel

0
Legend
Clamping zone
Rail position
Rail position
Once a module is secured in each of the zones (fig. ), additional clamps, i.e., ≥ , may be freely located on panel frame without
affecting the warranty. Loads marked with a
REC's internal testing process.
CAUTION
The center point of each clamp and the minimum grip length must be fully located in the same clamping zones to be rated to that load (fig. ).
If the panel is secured in zones with different load values, it is rated to the lowest load value only.
650 mm [25.6 in]
Clearance Gap
Test Load
(Design Load)
+ Pa /
mm
(+ Pa /
mm X
mm X
*
650 mm [25.6 in]
mm mm
Test Load
(Design Load)
Pa * + Pa /
Pa) (+ Pa / Pa)
+ Pa / Pa *
(+ Pa / Pa)
+ Pa / Pa *
(+ Pa / Pa)
were not certified as part of IEC
> mm
Test Load
(Design Load)
Pa + Pa / Pa
(+ Pa / Pa)
+ Pa / Pa *
(+ Pa / Pa)
+ Pa / Pa
(+ Pa / Pa)
/ testing; these have been evaluated by
REC Installation Manual - REC Solar Panels - IEC
Rev L .
0
< mm
Test Load
(Design Load)
X
X
X
/
Ref: PM IM