Table of Contents
Advertisement
B. Between two cutters: This set-up has the advantage of making two profile
cuts in a single pass. Although there is a Rub Collar (98, 99, 100) beneath a
Cutter, this set-up is safer than the previous set-up. Any lifting of the
workpiece will still cause the Cutter to make an uneven cut. A second pass
will correct the profile on the bottom edge, but the top profile will still have the
gouge from lifting the workpiece into the Cutter. (See Figure BB.)
c. Below the cutter: This set-up allows the cut to be viewed by the operator.
However, it is also the most dangerous. Any slight lifting of the workpiece will
cause the Cutter to make too deep of a cut. There is also increased risk of
kickback. It is NOT recommended to shape with a Rub collar below the
cutter. (See Figure cc.)
1.
Use safety equipment. Always wear ANSI-approved safety impact
eye goggles. Dust mask or respirator, and hearing protection must be
used for appropriate conditions.
SKU 95668
For technical questions, please call 1-800-444-3353
RUB cOLLAR
(98, 99, 100)
cUTTER
RUB cOLLAR
(98, 99, 100)
OPERATINg INSTRUcTIONS
cUTTER
BETWEEN
FIgURE BB
NOT REcOMMENDED
cUTTER
BELOW
FIgURE cc
PAGE 19
Hide quick links:
Advertisement
Table of Contents
