Table of Contents
Advertisement
Table Inserts:
1.
Table Inserts (53, 53A) are used to reduce wood chips falling into the machine
which could cause flying debris. Using the smallest Table Insert also covers any
unused portion of the bit below the surface of the Work Table (52).
(See Figure R.)
2.
Position, and snap in the Table Insert (53, 53A) you wish to use. (See Figure R.)
3.
Make sure the Table Insert (53, 53A) is seated and flush with the Work Table (52)
surface. (See Figure R.)
Belt Adjustment:
1.
The Wood Shaper uses a Belt (123) on two Pulleys (113, 127) to compensate
for different Belt positions as the Spindle (105) height is adjusted. To adjust the
V-Belt:
Loosen the two Hex Head Screws (134). Slide the Motor (129) position to
increase or decrease V-Belt (123) tension, so that the Belt is snug with about 1/4"
deflection when pressed lightly with your finger. Then, retighten the Hex Head
Screws. (See Figure S.)
SKU 95668
For technical questions, please call 1-800-444-3353
FIgURE R
WORK TABLE
V-BELT (123)
HEX HEAD ScREW
(134)
TABLE INSERT
(53, 53A)
(52)
FIgURE S
MOTOR (129)
PAGE 15
Hide quick links:
Advertisement
Table of Contents
