Rub Collars - Central Machinery 95668 Set Up And Operating Instructions Manual

the left to lower the Spindle (105). (See Figure Z.)
4. Retighten the Spindle Hand Knob (92) on the side of the Wood Shaper. DO NOT
overtighten the Knob. Only a small amount of tension is needed to keep the
Spindle (105) from moving during operation. (See Figure Y.)

Rub Collars:

1. When shaping workpieces that have irregular shapes, Rub Collars (98, 99, 100)
are a necessity. Some examples of when you would use a Rub Collar are raising
arched or tombstone door panels, round table tops, or any other cut that needs
to have its depth of cut limited.
2. There are three set-up positions for Rub Collars (98, 99, 100):
A. Above the cutter: This set-up is the safest and produces a most consistent
result. The only drawback is that the cut is on the underside of the
workpiece, out of view of the operator. However, if the workpiece lifts off the
Work Table (52) you simply run it through a second time to finish the cut.
(See Figure AA.)
SKU 95668 For technical questions, please call 1-800-444-3353
FIgURE Y
SPINDLE
HAND KNOB
(92)
RUB cOLLAR
(98, 99, 100)
cUTTER
FIgURE Z
SPINDLE
HEIgHT KNOB
(120)
ABOVE
FIgURE AA
PAGE 18