Fence Alignment - Central Machinery 95668 Set Up And Operating Instructions Manual

shaping tasks. The Fences (60) can be set at different positions to remove
material from the entire edge of the wood stock or set at the same position to
shape part of the edge.
2. Loosen the Lock Handle (61). (See Figure P.)
3. Adjust the position of the Fence (60) by turning the Knob (64). (See Figure P.)
4. Once the Fence (60) is in the desired position, re-tighten the Lock Handle (61).
(See Figure P.)

Fence Alignment:

1. To align the Fences (60) so they are parallel with each other, use a straight
edge that is long enough to span the entire length of the two Fences (60). (See
Figure Q.)
2. If the Fences (60) are not parallel, place shims (not included) between
the back of the Fence and the face of the Right or Left Fence Body
(57, 59). (See Figure Q.)
SKU 95668 For technical questions, please call 1-800-444-3353
FIgURE P
FENcE
(60)
LOcK HANDLE
(61)
FENcE (60)
FIgURE Q
FENcE
(60)
KNOB
(64)
FENcE
(60)
STRAIgHT EDgE
(NOT INcLUDED)
PAGE 14