Cleaning And Storage; Environment Protection; Ingress Protection (Ip) Ratings - Bahco BMVAT1000 Instruction Manual

"L". (3) Put back the battery cap and lock it by a coin.
CLOSE
WARNING: Please make sure the battery cap is
•
locked before any operation.
7. Specification
ual
, the
Voltage Range
E-".
f the
Voltage Bar Indication
the
C.
Accuracy
CH"
Response Time
Maximum
utes.
Current @ 1000V
ltage
Voltage Range
st,
e
hing,
System
Voltage Range
t
Phase Angle
Voltage Range
Continuity Resistance
ct
ase
Conducting Current
Battery
and
Temperature
hen
Humidity
ng
the
ange
CAT Category
GS LVD
g the
attery
EMC
IP code
e
Pollution Level
4
OPEN
Voltage Measurement
6 – 1000VDC
24 – 1000VAC
6/12/24/50/120/
230/400/690/1000V
± (3%+3)V
< 1s at 90% each voltage
< 3.5mA
High Voltage Indication
100V-1000V AC/DC
Phase Rotation Measurement
Three Phase 4 Lines
100V ~ 1000V
120± 5 degree
Non-Contact Voltage Sensing
> 90VAC
Continuity
0 ~ 1.3MΩ
50uA
Operating Environment
3V (AAA 1.5V x2)
0~50°C operation
-10~60°C storage
max 85% RH
Safety Certification
CAT IV 1000V
EN 61243-3
EN 61326-1
IP65
2
8. Cleaning & Storage
• Use a light damp cloth with neutral detergent for cleaning
the instrument. Do not use abrasives or solvent.
• Do not expose the instrument to the direct sun, high
temperature and humidity or dewfall.
• Remove batteries when the instrument will not be in use
for a long period.
• Do not lock the battery cap without batteries.
• Read the manual carefully and follow the safety guide for
any operation.
9. Measurement Category
Category IV is for measurements performed at the souce of
the low-voltage installation.
Category III is for measurements performed in the building
installation.

10. Environment Protection

– Do not dispose electrical appliances as
unsorted municipal waste, use separate
collection facilities.
– Contact your local government for information
regarding the collection systems available.
– If electrical appliances are disposed of in landfills
o dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your
health and well-being.
– When replacing old appliances with new ones, the retailer
is legally obligated to take back your old appliance for
disposal at least for free of charge.
11. Safety Symbol
Always check proper operation of the device on a
known working circuit before using.
Suitable for live working.
Caution, risk of electric shock. Under normal use,
hazardous voltages may be present.
Alternating current.
Both direct and alternating current.

12. Ingress protection (IP) ratings

Ingress protection numbers are used to specify the
environmental protection – electrical enclosure – of
electrical equipment.
The IP rating normally has two numbers:
1. The first number – protection against solid objects.
2. The second number – protection against liquids.
IP65:
The instrument is totally protected against dust and against
low pressure jets of water from all directions.
EN
5