3
WORK
3.1
Raising the motorcycle with the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
3.2
Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
1
0 0 1
3.3
Installing the front wheel
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Raise the motorcycle at the frame underneath the engine.
Lift stand (59229055000)
Neither wheel is in contact with the ground.
–
Secure the motorcycle against falling over.
401942-01
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, insert plug-in stand
dle.
Info
Remove the plug-in stand before riding.
402001-10
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
L00094-11
–
Position the front wheel.
The brake linings are correctly positioned.
–
Insert wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
L00092-11
into the left side of the wheel spin-
and bearing surface
p. 10)
.
M20x1.5
5
of the spacers.
35 Nm
(25.8 lbf ft)