Advertisement
1
Installing Shampoo Unit (Standard spec.)
1
Marking
Lay the accessory pattern paper on the floor at the installation position referring to the raising positions of
1
cold/hot water supply pipes and tape the pattern paper.
Mark the floor with a pencil at the positions of the shampoo unit base and the screw holes.
2
Remove the pattern paper.
3
2
Fixing the shampoo unit.
Detach the four screws on the shampoo unit.
1
Attach the chair mount frame to the shampoo unit. Then fix the shampoo unit temporarily with the screws
2
detached in
.
1
Fix the chair mount frame on the floor at the marked
3
position.
Tighten the screws that were loosely fastened in
4
Bolts to be used
(Accessory to shampoo unit):
Plywood floor:
Hex head tapping bolt +
Plain washer (8 mm x 65)
Concrete floor:
Anchor bolt + Plain washer
(M8 x 70, Anchor hole 8.5 m/m)
(Use a wrench with across flat 12 mm.)
Anchoring procedure
Pattern
paper
8.5 mm
Depth of
anchor hole:
Min. 50 mm
Floor
Drill the anchor holes of a
1
specific diameter and depth.
CAUTION
If the anchor bolt is tapped with its end contacting the bottom of the hole, the strength will be lowered. Proper
clearance must exist between the end of the anchor bolt and the bottom of the hole.
CAUTION
• Be sure to use the chair mount frame packing when fixing the chair mount frame.
• Be sure to use the plain washer when tightening the bolt.
• The center of the shampoo unit must be aligned with the center of the chair mount frame. (The
center of the chair mount frame is the notch of the chair mount frame packing.)
Clean each anchor hole
2
thoroughly using a vacuum
cleaner, with a narrow nozzle
attachment to reach into the
hole and remove all debris.
.
2
Center line
Chair mount frame packing
CAUTION
When using anchor bolts, do not use the spare hole in the
rear side. The bolts will make contact with the cover.
Rod
Plain
washer
2 to 5
mm
Insert the anchor, tapping it
3
lightly with a hammer to seat
it. Position the material, and
then drive the rod into the
anchor until it is snug.
6
*
Nut
Adjust the fastening strength
4
of the nut using a wrench etc.
Advertisement
