Table of Contents
Advertisement
pointer calibration
your new bandsaw is equipped with a fence mea-
surement system that includes a fence pointer,
which must be calibrated when the bandsaw is
first set up.
to calibrate the pointer:
1.
if the fence is mounted on the right-hand side
of the blade, remove it and re-install it on the
left-hand side of the blade.
2.
place the fence flush against the bandsaw
blade (figure 9).
figure 9. Fence flush with blade.
-14-
3.
loosen the pointer adjustment nut (figure
10) and set the pointer in line with "0" and the
measurement scale on the table.
figure 10. Calibrating fence pointer (screw out
of view).
4.
re-tighten the pointer adjustment nut.
Model g0513X2B (Mfg. since 5/11)
pointer nut
pointer
Advertisement
Table of Contents
