Table of Contents
Advertisement
3.
thread the fence handle into the fence, then
tighten the hex nut against the fence pivot
block (see figure 4).
pivot Block
Fence
handle
figure 4. Fence handle components.
4.
install the resaw fence lock handle (with the
washer and moving plate) onto the fence,
then slide the resaw fence over the moving
plate as shown in figure 5.
note: Leave the moving plate and lock han-
dle loose enough to slide on the fence.
resaw Fence
resaw lock
handle
figure 5. Attaching resaw fence to standard
fence.
5.
tighten the resaw lock handle.
6.
pull the fence handle up and place the fence
assembly on the rail.
7.
push the fence handle down to lock the fence
assembly in place.
Model g0513X2B (Mfg. since 5/11)
hex nut
Moving
plate
guide post
handwheel
secure the guide post handwheel onto the flat
part of the handwheel shaft with the M6-1 x 20
cap screw.
disabling & locking
switch
The power switch can be disabled and locked by
removing the key, as shown. Locking the switch
in this manner can prevent unauthorized opera-
tion of the machine, which is especially important
if the machine is not stored inside an access-
restricted building.
IMPORTANT: Locking the power switch with a
key only restricts its function. It is not a substitute
for disconnecting power from the machine when
adjusting or servicing.
Children or untrained people can be killed
or seriously injured by this machine. This
risk increases with unsupervised operation.
To help prevent unsupervised operation,
remove the key from the switch before
leaving machine unattended! Place key in a
well-hidden or secure location.
P O
W E
0
R
I
-11-
Advertisement
Table of Contents
