Table of Contents
Advertisement
motor brake
the motor brake is activated automatically when
the oFF button is pushed.
(Replaces Test Run
on Page 21)
to test run the machine:
1.
Follow steps 1-5 on g0513X Manual page
26.
2.
verify that the machine is operating correctly
by turning the switch disabling key (figure 6)
to "1" and turning the machine ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
6
figure
. g0513X2 switch disabling key and
on/oFF switch.
3.
press the oFF button to stop the machine.
-12-
4.
Without resetting the oFF button, press
the on button. the machine should not
start.
—if the machine does not start, the oFF but-
ton safety feature is working correctly.
—if the machine does start (with the stop
button pushed in), immediately disconnect
power to the machine. the oFF button
safety feature is not working correctly. this
safety feature must work properly before
proceeding with regular operations. Call
tech support for help.
5.
twist the oFF button clockwise so it pops
out. When the oFF button pops out, the
switch is reset and ready for operation (see
figure 7).
OFF Button
figure 7. resetting the switch.
6.
turn the switch disabling key to "0", as shown
in figure 6.
7.
try to turn the machine ON.
—if the bandsaw does not start, the switch
disabling feature is working as designed.
the test run is complete.
—if the bandsaw starts, immediately discon-
nect power. the switch disabling feature is
not working correctly. this safety feature
must work properly before proceeding with
regular operations. Call tech support for
help.
Model g0513X2B (Mfg. since 5/11)
Advertisement
Table of Contents
