Midea FP-90LTL085GETM-N1 User Manual page 9

One Touch
Follow steps no. 2 to 7 of Quick Wash, press ON/OFF button, then press Start/Pause button.
The washing machine will automatically weigh the laundry, select the appropriate settings
(water level, wash, time, rinse mode, spin time) and start the operation.
No need to manually select the wash settings.
Automatic Balance
If the laundry is unevenly distributed in the tub before spinning, vibration is likely to occur
during spinning. The washing machine can automatically adjust tub imbalance. If the
unbalance sensor detects strong vibration, the program to balance the wash load will
automatically commence.
When the machine adjusts imbalance, the "rinse" light flashes and water will be supplied to
a set level. Adjustment takes about 1 minute and then water is drained. Afterwards, the
spinning cycle will resume. The machine will make 2 attempts to adjust the imbalance.
If imbalance still occurs after the 2nd attempt, an alarm will sound and the user needs to
manually adjust the clothes distribution in the tub.
Fuzzy Logic Function
Fuzzy Logic Function
The "fuzzy" program automatically detects the amount of laundry and then
selects the corresponding water level. The "fuzzy" control is deactivated in the
following conditions: 1. If water is present in the tub at the start of
operation and 2. If the user selects a certain water level at the start of operation.
Power Failure Memory Function
In case of a power failure, the operation during which the power was interrupted will be
stored in the machine's memory and when power resumes, the machine will continue operation
where it left off.
Alarm function when the Top Lid is opened
If the Top Lid is opened during washing or spinning, an E3 alarm will be activated and
operation will stop. Closing the Top Lid will deactivate the alarm and operation will
automatically resume. When the Delay function has been activated, opening the
Top Lid will also trigger the E3 alarm. Closing the Top Lid will cancel the alarm and the
Delay function will resume.
Cleaning and Maintenance of the Washing Machine
End of Program
The washing machine will alarm after the washing
process to remind you to take out the laundry.
After the sound, the machine will automatically go
to its power-off state with no display and all lights
will be off.
Make sure to turn off the faucet and pull the power
plug after every use to avoid water leakage or fire
accidents
Clean the Water Inlet
After long time use, the water inlet mesh bag may be
blocked with dirt, clean it following there steps:
1. Switch on the power and the water faucet.
2. Let the washer work for 5 seconds so that the water
flows into the tub through the water inlet hose.
or
Clean the lint filter in the drain pump (for machines with drain filter)
1. Drain the water out of the 2. Loosen the pump cover
pump, use a container to collect counter-clockwise.
4. Clean the filter
5. Restore it and adjust the
convex place to align at the
pump hole.
Note: If the drain filter is not cleaned at proper time (every 10 times of use).
Drain problem could occur
Maintenance
Use gentle cloth to wipe off the water and dirt on the
surface of the machine after using it. Avoid using
detergent, propellant and other chemicals when
cleaning the surface of the
machine to prevent damage
to the plastic accessories.
Cleaning the Filter
After using the machine for a period, clean the filter
accordingly.
1. Take out the lint filter.
2. Open the filter (for Magic Cleaning Filter) or
reverse inside out the mesh bag (for normal filter)
and wash it clean with water.
3. Restore and put back the filter.
(only for magic filter)
(only for normal filter)
3. Take out the lint filter.
6. Tighten the pump cover