Midea FP-90LTL085GETM-N1 User Manual page 8

Wash Settings (Program)
1. Normal
For washing clothes with cotton fabric and daily wear.
2. Delicates
Has a gentle wash action and slow spin speed for light fabrics such as silk.
3. Jeans
For washing thick clothes and those with heavy stains.
4. Mini wash
Ideal for washing small loads of laundry, using low water level.
5. Intensive
Use this program, to wash heavily-soiled clothes.
6. Bulky
Washing ability is strong and can wash large pieces of laundry.
7. Quick
Washing time is short. Suitable for washing lightly-stained clothes.
8. Drum dry
To dry the laundry without heating, to achieve the result of clothes being
dried in a room.
Delay
This function postpones the start of the washing process and the delay time is 1-24 hours.
After selecting the wash settings, "long press" the Delay button repeatedly and the delay
time will increase by 1 hour. When the display shows 24 hours and the Delay button is
pressed, the display light will turn off and the Delay function turns off correspondingly.
Child Lock
This function can be activated only after the selected program starts.
Spin only
1. Press the ON/OFF button.
2. Press the Spin button to choose the spin time
3. Press Start/Pause button.
The washing machine will operate a single process.
Note: For wash only, follows steps in "Spin only" but press the wash button instead of the
Spin button, to choose the wash time. Before pressing the Start/Pause button, press the
Spin button repeatedly until the light goes out.
Tub clean
This function removes dirt accumulated on the inside and outside surfaces of the drum. In the
standby mode, press Spin & Program buttons at the same time, to set to Tub clean.
Afterwards, press Start/Pause button.
Water cycle (Rinse hold)
After the rinsing cycle is finished, water will not be drained and another set of clothes can
be rinsed using the same water. To commence the Spin cycle, select the Spin time after
rinsing is done and then press Start/Pause button.
Program pause and resumption
The program will stop if the Start/Pause button is pressed and will resume if this button is
pressed again.
Automatic power shut off
If the Start/Pause button is not pressed after the ON/OFF button is pressed, power will
automatically cut off after 10 minutes.
When an operation stops, the buzzer will sound continously 6 times and then the power
will automatically cut off.