Midea FP-90LTL085GETM-N1 User Manual page 4

Unpacking
• Remove the machine from box and take out the
foam board at the bottom.
.
• Take out the accessories inside the tub.
• Trial operation or washing on the foam cushion
is strictly prohibited.
• Install the rat-proof base cover at the bottom of the machine.
installed
Installing Water Inlet Hose
(For Models with Double Screw Thread Inlet Pipe)
• Connect the water inlet pipe screw
(with metallic ring) to the water faucet
• Connect the clamping nut (with rubber
seal ring inside) of the water inlet hose
to the washer inlet valve.
Note: When tightening the
clamping nut, evenly apply the
force and do not twist the water
inlet valve to avoid breaking the
water inlet valve joint.
If the power cord is damaged, it must be replaced by the manufacturer, its service agent,
similarly-qualified persons, in order to avoid hazards. The new hoses supplied with this product
should be used; do not use old hoses. Opening at the base must not be obstructed by carpets
or similar items. This appliance is for indoor use only.
Base foam cushion
Completely insert the drain hose into the
washing machine drain outlet
Secure the connection, with the clamp provided
do not
Installation of Water Inlet Pipe
(For Models with Single Screw Thread Inlet Pipe)
1 2
Push down the slide jacket
to expose the small ball and
enable separation of connector
socket from the quick-release connector.
4
A
5mm Junk ring
B
The connection socket consists
of parts A and B. Before installation,
A and B must have a vertical gap of
about 5mm, or be directly disconnected.
If the bore of water tap is larger,
remove the plastic junk ring of part A.
To connect: Push down the slide jacket of
quick-release connector ( 4 small
balls must be exposed ),
insert it into the connection
socket and then push upward.
Release the slide jacket. If it
is required to supply water,
6
simply open the water tap.
Connect
Tightly screw the other end of the water inlet hose
to the water inlet valve. (with rubber seal ring inside).
Note: When tightening the clamping nut, evenly apply
force and do not twist the water inlet valve, to avoid breaking
of the water inlet valve joint.
3
Small ball
.
Remove the four screws of part
5
A and put part A horizontally
over the mouth at the end of
water tap (the mouth at the end
of water tap must be flat and
smooth. Flatten it by filing if it is
not flat) and push it upward with
force making the rubber washer
firmly press the plane center of
water tap mouth. Then tighten
the screws sequentially.
7 After that, tightly screw on part B.
To detach: Close the water tap, push down
the slide jacket of the
quick-release connector and
pull out th quick-release
connector.