Preparing a Rear Door Heat eXchanger
If you purchased an IBM Rear Door Heat eXchanger with your Cluster 1350, it is
attached to the rack unit by an IBM service representative during the hardware
installation.
After a door is installed, the customer is responsible for filling the fluid, draining
the fluid, and connecting or disconnecting the plumbing connections when the unit
arrives or is replaced by an IBM service representative. You might want to plan for
extra space around the racks to allow movement of racks for fluid service. See the
Installation and Maintenance Guide that comes with the Rear Door Heat eXchanger
or go to http://www.ibm.com/systems/support/ for more information.
18
IBM System Cluster 1350 Installation and Service Guide