Panasonic NR-YW590Y Operating Instructions Manual page 101

Moisture control of vegetable case
1 After pulling out the Vegetable case, the Moisture control is located at the back of the Vegetable case.
2 Slide the Moisture control upward to remove it.
Remark
After cleaning by water, wipe it or let it dry.
For tough stains, dilute (neutral) kitchen detergent, and gently wash with a soft toothbrush,
then rinse thoroughly with water.
Prime Fresh case
Removing
1 Pull out the Prime Fresh room door completely.
2 Gently lift the front of the Prime Fresh case and remove it diagonally.
Attaching
1 Pull out the Prime Fresh room door completely.
2 Gently place the Prime Fresh case diagonally back to its original position, until it
reaches the end.
Remark
When installing the case, make sure to install the front and the back of the case properly.
The front of the case has the word "Front".
The aluminum heat transfer plate can be removed; however, remember not to hold it with
wet hands when the aluminum plate is cold, as there may be a risk of frostbite.
If cleaning by water, wipe the aluminum plate or allow it to dry before reinstalling into the
refrigerator.
Do not wipe the lubricant off the steel guide rails or the contact surface of the guide rail.
If you have wiped out the lubricant, please contact with the Service Center.
1 Open the lid and clean the Water tank with water.
2 Rotate the Water filter to remove the hook and
remove the Water filter.
3 Gently wash the Water filter in water.
4 Remove the seal rubber on the edge and clean it
with water
5 Put the Water filter and rubber back into place.
Remark
If there is water deposits or pipe blockages in the
Once every 3 months
Once every 3 months
Aluminum heat transfer plate
(Note that the aluminum plate
is easy to be scratched and
deformed)
Water supply tank
Weekly
Water filter
Rubber gasket
29