Midea EGV 4.45 User Manual page 93

Step 4: Installation steps for the dishwasher
Please follow the installation steps specified in the installation drawings.
1. Apply the condensation strip under the worktop of the cabinet.
Ensure that the condensation strip is flush with the edge of the
worktop. (Step 2)
2. Connect the inlet hose to the cold-water supply.
3. Connect the drain hose.
4. Bring the dishwasher into position. (Step 4)
5. The dishwasher must be secured in place. There are two ways to do this:
a) Normal worktop: Insert the installation hook into the slot on the
side and fasten it to the worktop with the wood screws.
b) Marble or granite worktop: Secure the side with the screw.
6. Connect the power cord.
7. Align the dishwasher. The rear foot can be adjusted from the front of
the dishwasher by turning the Phillips screw in the middle of the
dishwasher base using a Phillips screwdriver. To adjust the front feet,
use a slotted screwdriver and turn the front feet until the dishwasher is
level. (Step 5 to Step 6)
8. Install the cabinet door on the outer door of the dishwasher. (Step 7 to
Step 10)
9. Adjust the door spring tension by turning an Allen key clockwise to
tension the left and right door spring. Failure to do so could damage
your dishwasher. (Step 11)
A
B
36