Midea EGV 4.45 User Manual page 85

Dishwasher care
Frost protection measures
In winter, frost protection measures should be taken for the dishwasher.
After each wash cycle, proceed as follows:
1. Disconnect the power supply to the dishwasher at the power source.
2. Switch off the water supply and disconnect the water supply line from the
water valve.
3. Drain the water from the inlet line and water valve. (Use a bowl to trap the
water)
4. Reconnect the water supply to the water valve.
5. Remove the filter at the bottom of the tub and suck up the water at the
bottom.
After each wash cycle
Switch off the water supply to the appliance after each wash cycle and
leave the door open slightly so that no moisture or odors are trapped
inside the appliance.
Pull out the plug
Always pull out the plug from the socket before cleaning or carrying out
maintenance work.
No solvents or abrasive cleaning agents
Do not use solvents or abrasive cleaning agents to clean the outside and
rubber parts of the dishwasher.
Use only a cloth with warm soapy water.
To remove stains from the inside surface, use a cloth moistened with water
and a little vinegar or a detergent specially made for dishwashers.
For longer periods of non-use
It is recommended to perform a wash cycle with an empty dishwasher,
then unplug the appliance, turn off the water supply and leave the door
open slightly.
This will help to extend the life of the door seals and prevent the formation
of odors in the appliance.
28