Wilson Electronics SIGNALBOOST iBooster 271220 Installation Manual page 5

2. Attach the Mounting Bracket
Three different mounting brackets are provided for attaching the iBooster to your vehicle's dash .
Choose the appropriate one for your application . See bracket specific mounting options below .
3. Attach the iBooster
Once you have installed your selected mount in the desired location, attach the cradle by aligning the
rectangular hole on its back with the tab on the mount . Grasping the sides of the cradle, slide it downward
approximately ¼ inch into place .
OPTION 1
Air Vent Bracket
1 . Slide the bracket clips into
the chosen vent location
until they snap into place . If
necessary, use a thin-bladed
screwdriver to gently pry the
clips apart as they slide into
the vent .
2 . Position the moveable arm
at the base of the bracket to
achieve the desired angle
and to provide additional
stability for the iBooster .
4. Powering up the Wilson Electronics iBooster
Make sure the outside antenna cable is connected before powering up the signal booster.
Connect the mini-USB plug on the power cable to the signal booster's mini USB port on the iBooster .
Insert the adapter into the vehicle power adapter outlet of your vehicle .
The signal booster may remain on all the time . However, leaving the signal booster on in a vehicle
when it is not running can discharge the battery in a day or two .
A good option is to power the signal booster through the ignition switch so that the signal booster
is turned on and off with the vehicle . The 12 volt AC socket on many vehicles is shut off with the
ignition key .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com
®
OPTION 2
Adhesive Bracket
1 . Clean the area where the bracket is
to be mounted with rubbing alcohol
and a soft cloth . Allow to dry .
2 . Peel the backing to expose the
adhesive and press the bracket onto
the desired location in the vehicle .
Note: be sure the tab is positioned
vertically,
not horizontally.
3 . Allow the adhesive to cure for
24 hours before you attach the
iBooster .
4 . Once the cradle is attached, you
can adjust the angle of the adhesive
bracket by applying gentle pressure
to the top or bottom of the iBooster .
Lock bracket into position with a
phillips head screwdriver once
desired angle is established .
OPTION 3
Adhesive/Screw Swivel Bracket
This mount allows for adhesive
mounting as well as more permanent
screw mounting . This option
is designed to swivel when the
knurled nut is loosened, for greater
adjustability of the iBooster viewing
angle . For adhesive mounting, follow
steps 1, 2 and 3 of Option 2 .
For screw mounting, use an ice
pick or an awl to punch through
the adhesive and expose the four
screw holes in the bracket . You must
provide the screws of an appropriate
size for your particular application .
Using the bracket as a template,
mark the locations for the screws as
shown, drill pilot holes, attach the
bracket with adhesive, and tighten
all screws .
Signal Booster
®
Hours: 7 am to 6 pm MST.
4