Kenwood DV-2070 Instruction Manual page 49

The recommended setup for [7 Digital Audio Output] is variable depending on the equipment connected to the digital audio
output. Set up this item by referring to the following table.
Recommended setup for [7 Digital Audio Output]
Digital Audio Output Connection
[7 Digital Audio Output] Setup
1 LPCM (DVD) 2 Dolby Digital
3 dts
When no equipment is connected Off (Factory setup) Bitstream (Factory setup) Off
When an amplifier having a digital input but not incorporating
a Dolby Digital (AC-3) decoder is connected
PCM (*1)
PCM (*2)
Off
When a Dolby Digital (AC-3) decoder is connected PCM CD
Bitstream
Off
When a Dolby Digital (AC-3) or DTS decoder is connected PCM (*1)
Bitstream Bitstream (*3!
i* 1
1 The signal from the audio output of the player is converted into a 48 kHz/16-bit signal |ust like the signal output from the digital audio output. Therefore,
it vou want to plav high audio quality software with 48 kHz/20-bit or 24-bit or 96 kHz recording, do not connect the equipment such as an amplifier or
decoder to the digital audio output (i.e. set [1 LPCM (DVD)) to " 1 Off ") and connect the equipment directly to the audio output jacks.
(* 2: Set to " PCM" when connecting the equipment other than a Dolby Digital (AC-3) decoder If this item is set to " Bitstream". loud noise may be produced
and speakers may be damaged.
■"VC*
Noise mav interfere with the speaker output if the player is connected to a piece of equipment which does not incorporate an DTS decoder. Never
connect the piayer to equipment without a built-in DTS decoder.