Trouble Shooting - Electrolux TE1120 User Manual

22

13 Trouble shooting

Problem* Possible cause
The tumble dryer is not connected to mains supply.
The loading door is opened.
The ON/OFF button was not pushed.
The tumble dryer does
The Start/Pause button was not pushed.
not operate.
The appliance is in the standby mode.
The filter is missing or in wrong position.
The E10 error code on the display - clogged filter.
The E59 error code on the display - dryer overloaded.
Incorrect program selection.
The EF0 error code on the display - filter abnormally
dirty.
The filter is clogged.
Unsatisfactory drying
Too high volume of the load.
result.
The airflow grill is clogged.
Dirt on the humidity sensor in the drum.
Incorrect remaining laundry moisture degree.
The condenser is clogged.
The filter is not locked in position.
The loading door does
not close.
The laundry is locked between the door and the seal.
You try to change the program or the option after the
start of the cycle.
Err (Error) on the
display.
The option you try to activate is not applicable with the
selected program.
No drum light. Defective drum lamp.
Abnormally elapsing The time to end is calculated on the basis of the volume
time on the display. and dampness of the laundry.
The water container is full.
Program inactive.
Too small laundry volume.
Drying cycle too short.
The laundry is too dry.
The EF0 error code on the display - filter abnormally
dirty.
The filter is clogged.
Drying cycle too long.
Too high volume of the load.
*****
The laundry not spun sufficiently.
Very high room temperature - this is not the appliance
malfunction.
* If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on.
Make a selection of the new program. Push the Start/Pause button. If the tumble dryer still does not operate - con-
tact the service centre and give the error code.
** See chapter: "Care and
*** Follow the program description - see chapter: "Programs".
**** See chapter: "Hints and
***** Note! After maximum 5 hours the drying cycle ends automatically.
User manual
cleaning".
tips".
Remedy
Connect in at mains socket. Check fuse in fuse box (do-
mestic installation).
Close the loading door.
Push the ON/OFF button.
Push the Start/Pause button.
Push the ON/OFF button.
Insert the filter in the right position.
Clean the filter**
Unload part of the laundry. Obey the maximum load.
Do the selection of the applicable program.***
Clean the filter.**
Clean the filter.**
Obey the maximum load volume.
Clean the airflow grill in the bottom of the appliance.
Clean the front surface of the drum.
Adjust remaining laundry moisture degree.****
Clean the condenser.**
Put the filter in the correct position.
Put the load correctly in the drum.
Turn the tumble dryer off and on. Make the new
selection.
Turn the tumble dryer off and on. Make the new
selection.
Contact the service centre to replace the drum lamp.
The automatic procedure - this is not the appliance
malfunction.
Drain the water container, push the Start/Pause button.
**
Do the selection of time program. The time value must
be related to the load. To dry one item or small quanti-
ties of the laundry, we recommend to use short times.
Do the selection of the time program with longer time.
Clean the filter.**
Clean the filter.
Obey the maximum load volume.
Spin the laundry correctly.
If possible, lower the room tem-perature.