Table of Contents
Advertisement
is full, shut OFF the water pump and remove
the non-toxic drinking water hose.
W
P
ATER
RESSURE
(C
S
USTOMER
UPPLIED
Not using a water pressure regulator when
using city water may cause the o-rings to
fail. To prevent damage to the plumbing
system or components when using the city
water
connection,
regulator rated for 40 lbs. is recommended.
Excessive
pressure
systems may be encountered in some parks,
especially
in
mountain
pressure regulators are available to protect
your system against such high pressure. A
regulator of this type is recommended to
prevent damage to the plumbing system or
components.
Water
(customer supplied) are available from your
Dealer to protect the park trailer plumbing
system against such high pressure.
12-V
W
P
OLT
ATER
(I
S
E
)
F
O
QUIPPED
Once activated, the water pump (also known
as the on-demand pump) will self-prime, and
provide water. The water pump continues to
run until approximately 45 lbs. of pressure is
achieved and shut off. The water pump will
automatically re-start when pressure drops.
Some cycling may occur, depending on the
volume of water being released. The water
pump is engineered by the OEM with a check
valve to prevent water from back flowing into
the fresh water supply tank
The water pump switch should be in the
OFF position when the park trailer is left
unattended for any amount of time. If
something would happen to the water
system, this may help limit water damage
to a smaller area.
R
EGULATOR
)
a
water
pressure
from
water
supply
regions.
Water
pressure
regulators
& S
UMP
WITCH
PLUMBING SYSTEMS
Fig. 7.3 Water pump strainer
Periodically check the in-line water pump
strainer for accumulated debris. To clean,
shut off the water pump, unscrew the clear
cap, remove the re-useable metal strainer and
clear any debris, then reinstall.
Dry camping
When you want to use water in your park
trailer and the park trailer is not hooked up to
city water, you will need sufficient 12-volt DC
power to run the water pump.
W
H
ATER
EATER
Do not replace any component part with an
accessory part that is not authorized by the
water heater manufacturer, such as an
"add-on" electric heating element. Such
items are not approved to be installed and
could create an unsafe condition and will
void all warranties.
The water heater is designed to heat water
quickly and efficiently. The water heater
manufacturer has preset the sensing limit to
maintain the water temperature when the
water heater is activated. Hydrogen gas in the
water lines may result if you have not used
the water heater for two weeks or more. To
reduce the risk of injury under these
conditions, open the hot water faucet for
several minutes at the kitchen sink before you
use any electrical appliance connected to the
hot water system. If hydrogen is present, you
probably will hear an unusual sound such as
SECTION 7
47
Advertisement
Table of Contents
