Advertisement
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected
to the cold water pipe. If it is
connected to the hot water
pipe, it may cause the purifier to
malfunction.
Close Main
Water pipe
Close Main
Water pipe
4. After connecting the water supply to the water
filter, turn your main water supply back on and
dispense about 3L to clear and prime the water
filter.
Connecting the water line to the
refrigerator
1. Remove the cap from water line on the unit and
insert compression nut to the water line on the
unit after disassembling from provided water line.
2. Connect both water line from the unit and water
line in the kit.
3. Tighten the compression nut onto the
compression fitting. There should be no gaps
between (A, B & C )
4. Turn water on and check for any leakage.
Loosen a
Water Line
from unit
Water Line
from unit
08_ setting up
DA68-01817M-EN.indd
8
No gap
Remove
cap
No gap
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the water
line, cut off 6.5mm
of the plastic tubing
to make sure you
get a snug, leak-free
connection.
Before being used, the leakage in these
places should be examined.
CAUTION
• Samsung Warranty does not cover WATER LINE
INSTALLATION.
• It will be done at customer's charge unless the
retail price includes installation cost.
• Please contact Plumber or Authorized Installer for
the installation if needed.
• If Water leakage occurs due to improper
installation, Please contact installer.
SETTING UP THE
REFRIGERATOR
Now that you have your new Refrigerator installed in
place, you are ready to set up and enjoy the features
and functions of the appliance. By completing the
following steps, your Refrigerator should be fully
operational.
1. Place the Refrigerator in an appropriate location
with reasonable clearance between the wall and
the Refrigerator. Refer to installation instructions
in this manual. (P8. Selecting the best location for
the Refrigerator)
2. Once the Refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour. The Freezer
will get slightly chilled and the motor will run
smoothly.
4. After powering the Refrigerator, it will take a few
hours to reach the appropriate temperature. You
can store food and drinks in the Refrigerator after
the temperature is sufficiently cool.
2011.1.11
5:14:16 PM
Advertisement
