Installation Instructions For Pump Drive With Sae Flange And Fp Flexplate Coupling; Installation Instructions For Adi Pump Drives - DANA BREVINI BZ1-204 Installation And Maintenance Manual

INSTALLATION INSTRUCTIONS FOR PUMP DRIVE WITH SAE
6.3 INSTALLATION INSTRUCTIONS FOR PUMP DRIVE WITH SAE FLANGE AND FP FLEX-
PLATE COUPLING:
• Check that the spigots and coupling surfaces of the pump drive and the motor are clean and have not been dented.
• Use grease or oil to lubricate the coupling spigots and the housing seat.
• Pull out the Flexplate from the pump drive shaft.
• Attach the Flexplate on the flywheel using class 8.8 bolts and tighten them applying a torque as indicated in the paragraph
"Bolt Tightening Torque Table:" page 23. - Install the pump drive making sure that the shaft fits correctly into the hub that
is already fastened on the flywheel and that the spigot of the housing correctly matches the motor spigot.
• Insert all the bolts into the housing (class 8.8) and tighten them applying a torque as indicated in the paragraph "Bolt Tight-
ening Torque Table:" page 23.
NOTE:
The Flexplate hub must not be attached to the pump drive shaft but must be free to slide.
NOTE:
with regard to assembly, to install Dana Incorporated supplies without Couplings or Flexplate refer to the relative man-
ufacturer's handbook.

6.4 INSTALLATION INSTRUCTIONS FOR ADI PUMP DRIVES:

Check that the pump drive is solidly attached to brackets or support structures: for this purpose it should be recalled that the
pump drive should never be fastenedusing vibration-damping elements. Use bolts with a minimum class 8.8 and tighten them
applying a torque as indicated in the paragraph "Bolt Tightening Torque Table:" page 23.
18 Dana Incorporated IMM-0007EN Pump Drives BZ