Reverse osmosis water filtration system (22 pages)
Summary of Contents for Waterdrop WD-AS08
Page 1
15-100 psi/100-689 kpa Flow rate 1.6 gpm/6.0 lpm (tested under 60psi) Feed water requirement Municipal tap water WD-AS08: Up to 1 year/8000 gallons Filter capacity WD-AMS08: Up to 1 year/8000 gallons (Note: Actual life varies according to local water quality.) Precautions •...
Page 2
Installation of the filter system Step 2. Connect the Water Supply (cold water only) How to Use the Quick-Connect Fittings (To connect) If the tubing is not fully inserted, no seal will be created, and leakage will occur. When the tubing is fully inserted, put the blue lock clip on the tting. It will lock the tubing in place and prevent it from falling o .
Page 3
Cartridge change instructions Step 5. Connect Tubing (Figure 7) 1. Install the Inlet Water Tubing Step 1. Remove the Old Cartridge Connect the inlet water tubing from the feed water adapter to the inlet water port and pop the Turn o the water supply to the system. Open faucet to release the pressure and drain the water. lock clip on the tting;...
Page 4
Q: Why doesn't the TDS value lower after filtration? A: The main purpose of this Waterdrop lter is not to remove TDS. TDS stands for total dissolved solids, and it is basically composed of inorganic salts and a small amount of organic matter. The lter can remove harmful substances while keeping bene cial trace elements.