Memory Transmission - Sharp UX-CL 220 Operation Manual

Sending a Fax From Memory
6
When you are ready to begin transmission, press
A Transaction Report is automatically printed out after Broadcasting is
completed. Check the "Note" column of the report to see if any of the
destinations are marked "Busy" or have a communication error code. If so,
send the document to those destinations again.

Memory transmission

You can also send a fax through memory when sending to a single
destination. This is convenient when sending to destinations where the line is
often busy, as it saves you from waiting to pick up the original document and
frees the feeder for other operations.
To send a fax through memory, load the document, press
dial using one of the following methods:
Press the number keys to enter the fax number and then press
Press
Press
If the memory becomes full...
If the memory becomes full while the document is being scanned, MEMORY
IS FULL and SEE MANUAL will alternately appear in the display.
START/MEMORY
Press
to that point in memory. The remaining pages will be ejected from the
feeder. After transmission, the memory will be cleared and you can transmit
the remaining pages. You will also need to transmit the page which was
being scanned when the memory filled up.
STOP
Press
86
repeatedly to select an auto-dial number and press
once to select the last number dialed and press
if you want to transmit the pages which have been stored up
if you want to cancel the entire transmission.
START/MEMORY
.
START/MEMORY
, and then
START/MEMORY
START/MEMORY
START/MEMORY
.
.
.