Velleman CAMSCC3G Manual page 8

•
A PIN code must only be entered the first time the video call services are used. Once the
number is added to the device's memory (List of Authorisations), it will always be
permitted to connect to the device without the need to enter a PIN code.
Disconnecting a video call
•
The user interrupts the connection of the video call from their video phone.
•
The transmission of images recorded by the CAMSCC3G is interrupted and the video call
is disconnected.
Note 2: for safety reasons, the device always keeps a "List of Authorisations" stored in its
internal memory where it saves information on authorised users.
Only authorised users can use the services supplied by the device.
The List of Authorisations can save information on up to 20 users. To be automatically
added to the List of Authorisations, users must video call the device and enter
correctly enter its PIN code. The first user on the list is the Administrator, who is
authorised to configure the device by using SMS commands (please see the
"management" section).
Note 3: if a video call is made to the device by a user not on the list – once 20 authorised
users are listed and stored in the memory - the device will not recognise the caller,
who will be unable to connect to the device.
Warning 1: do not conceal your number while making a video call. The device will be
unable to recognise the caller and will refuse the connection.
Note 4: CAMSCC3G video services can be used even when the charger is disconnected. A
video call will not be connected if battery capacity is insufficient (below 5%).
Note 5: Video calls will be terminated if battery capacity has reached its minimum
operative level (below 5%) and an authorised user calls and activates the device. The
user will receive a warning that the battery is low before the call is terminated.
Note 6: the CAMSCC3G must be placed in a fixed position. To ensure that video call
quality remains high, place the device in an appropriate position checking the network
LED [J] - which shows the strength of the radio signal received by the device.
10. Advanced functions for the limited access mode
Management
•
Only the administrator - the first user saved on the device's List of Authorisations – is
authorised to change settings on the List of Authorisations.
•
The Administrator can send commands to the device using SMS text messages. These
can be used to change a number of settings on the List of Authorisations.
•
The Administrator can use 6 different commands. They are:
1) Change the number of users saved on the List of Authorisations;
2) Change the Administrator's number;
3) Delete an authorised user;
4) Delete all authorised users;
5) Enter a number as an authorised user;
6) change the PIN code.
Note: SMS COMMANDS are not caps sensitive.
Warning: Should the Administrator change his/her video phone – for example following
an MNP request – we recommend the new number be saved as Administrator. For any
problems connected to an Administrator number change, please contact Customer
Services.
1) To change the number of users saved in the List of Authorisations
• The List of Authorisations has been programmed to save 20 authorised users. The
Administrator can change this predefined number to any number between 1 and 20
by sending an SMS message to the device containing the following text:
09/08/2011
CAMSCC3G
#modlist*[NUMBER]#[PIN]#
8
Rev. 01
®
©Velleman nv