Administrator Management - Velleman CAMSCC3G Manual

Fastening the camera to the bracket
Refer to the illustration on page 3 of this manual. Make sure to insert the washers [N] in
the indicated places.
Terminal box wires and cabling
Refer to the illustration on page 3 and the overview in §4 of this manual.

8. Administrator management

Administrator management and alarm calls
•
The administrator – the person authorised to send configuration commands – is defined
when the first video call to the device is made.
•
When asked for a PIN number, enter the code found inside the bag stored in the device's
box.
•
The CAMSCC3 will call the administrator number during an alarm.
9. Activation
Connecting the Charger
•
Insert the charger into the CAMSCC3G as indicated in the illustration on page 3 of this
manual.
•
Plug the charger into the 12VDC input [F].
•
The Battery and Network lights on the device will turn red and flash rapidly (once every
second) on an off during this first phase.
•
Once the device registers that a charger has been inserted, the battery LED [H] will turn
on. Battery status is described in the figures below.
•
If the battery LED [H] is red and flashes rapidly (once every second), it is out of charge.
The battery takes approximately 30 minutes to charge up to its minimum operative
level. Do not switch on the device if the battery is below its minimum operative level. If
the battery LED [H] is on and flashing slowly (once every 3 seconds), the battery has
been charged up to its minimum operative level.
•
Battery status is described in the figure below.
09/08/2011
CAMSCC3G
6
Rev. 01
®
©Velleman nv