Advertisement
INSTALLATION
1. Assemble the decorated cover, hinge sleeve and hinge shaft together. Insert the
assembly into the bottom hinge. Then move the door glass to insert the decorated cover
into the bottom fixture.
2. Hold the door glass upright. Insert the limiting hinge assembly into the top hinge from the
top frame. When the door glass hangs down due to gravity, pre-tighten the limiting hinge
assembly with a screw.
1. 将下固定座装饰盖、 轴套、 轴安装在一起， 套入门玻下铰链， 然后移动门玻将下固定座装饰盖
套入下固定座。
2. 扶正门玻， 将限位铰链组件， 从上横梁插入门玻上铰链， 门玻自然下垂， 用螺钉预锁紧限位铰
链组件。
1. Install the seal at bottom of the panel glass. Insert the panel glass into the vertical frame.
2. Install the seal on the top and side of the panel glass.
3. Install the bottom bumper block of the panel glass.
1. 安装固玻底部胶条， 将固玻装入竖材。
2. 安装固玻顶部和侧边紧固胶条。
3. 安装固玻底部定位件。
1. Apply sealant onto both sides of the left and right jambs and also onto the edges of the
bottom fixture.
2. If a seal is installed, apply sealant onto its bottom edges.
1. 墙材两侧与底部固定座边沿打胶固定。
2. 带挡水条淋浴房， 在挡水条底部边沿打胶固定。
1415130-T01-A
安装
1. Install the handle. Install decorated seals onto the top frame, vertical frames and corner
frame.
2. Install the waterproof seal at the door glass side. Properly adjust the door glass. Tighten
the limiting hinge assembly and the decorated cover.
3. Install the waterproof seal at bottom of the door glass.
1. 安装门把手。 安装上横梁、 竖材、 转角边框上的装饰胶条。
2. 安装门玻侧挡水胶条， 调整好门玻的位置， 锁紧限位铰链组件,锁紧下固定座装饰盖。
3. 安装门玻下挡水胶条。
STEP
7
1. Install the end caps onto the top of the side panel glass jamb, corner jamb and vertical
frame.
2. Install decorated seals onto the top frame, vertical frames and corner frame.
1. 安装侧固玻墙材、 转角墙材和竖材顶部端盖。
2.安装上横梁、 竖材、 转角边框上的装饰胶条。
STEP
9
STEP
11
-4-
STEP
8
STEP
10
Advertisement
