Kohler ENGLEFIELD TAPWARE STUDIO 20149A-4 Installation Instructions

STUDIO Pin Lever Wall-Mount Basin Mixer
SPARE PARTS LIST
7
8
9
No. Description Part No.
1 Pin Lever 1329093-**
2 Bonnet 1250279-**
3 Nut 1250281
4 Cartridge 1372775 11
5 Mixer Face Plate 1329213-** 12
O-Ring - Mixer
6 1329214 13
Face Plate
7 O-Ring 1250325 14
8 Spout Face Plate 1329215-** 15
9 Spout Adaptor 1250328 16
10 O-Ring 1250324 17
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with a clean
soft cloth. Many cleaners may contain such chemicals as ammonia, chlorine, toilet chemicals etc., which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Englefield tapware.
CONTACT AND WARRANTY INFORMATION
NEW ZEALAND AUSTRALIA
KOHLER NZ LTD KOHLER AUSTRALIA
Free Ph: 0800 100 382 Free Ph: 1 800 ENGLEFIELD
Free Fax: 0800 664 488 (1 800 364 533)
www.englefield.co.nz
www.englefield.com
For warranty information, please visit our website
1329095-AN2-C Jan 2020
INSTALLATION INSTRUCTIONS
6
5
4
10
16
17
11
13
12
14
Grub Screws 1250284
15
Spout 1329216-**
Washer 1250285
Aerator 1250293
Aerator Shell 1250290-**
Grub Screw 1250284
** Please specify a colour when ordering:
-CP (Chrome),
-BN (Brushed nickel),
Plug 1250283-**
-BL (Matte Black)
Page 4
INSTALLATION
INSTRUCTIONS
TAPWARE
3
2
1
1329095-AN2-C
Englefield
Pin Lever Wall-Mount
STUDIO
Basin Mixer
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of
publication. ENGLEFIELD reserves the right to make changes in product charac-
teristics, packaging, or availability at any time without notice.
Please leave this installation guide for the consumer as it contains important
information.
NOTES:
1. Flush the water supply pipes thoroughly to remove any debris.
2. An in-line water filter must be used with this product.
3. If possible, install this mixer before installing basin.
4. Ensure all local plumbing codes are observed.
5. Recommended working pressure: 100kPa to 500kPa.
6. Maximum working pressure: 800kPa.
7. If pressure exceeds 500kPa, a pressure limiting valve must be installed.
8. All installations should comply with the relevant requirements of AS/NZS 3500 and
AS/NZS 6400.
ROUGH-IN
G1/2"
G1/2"
185
120
Jan 2020
20149A-4
168
85.5
185.5
Englefield