l
g
amination
uide
This manual provides general guidelines and is only
a general reference guide. Different settings may be
suitable as the lamination time and materials change.
Test materials before running good materials through
the machine.
•
Do not attempt to laminate abrasive or metal
objects such as staples, paper clips and glitter,
as they may damage the rollers.
•
Do not force items into the nip area of the rollers.
An item that is not easily drawn into the laminator
by the rollers is probably too thick to laminate.
•
Wrinkles may result if an attempt is made to
reposition an item once it has been grasped by
the rollers.
•
Do not stop the laminator before an item has
completely exited the pressure rollers. Even
a momentary stop may cause a mark on the
laminated item.
•
Good, consistent lamination is a result of
combining proper tension and roller pressure.
•
Do not combine thick and thin items at the same
time, as this will result in a poor edge seal around
the thinner material.
Page 6-12
640t – Installation and Operating Instructions