Table of Contents
Advertisement
l
f
oading
ilm
The 640t laminator runs poly-in and
poly-out pressure sensitive adhesive (PSA) films.
Poly-in means the adhesive side of the film is on the
inside of the film roll. Poly-out means the adhesive is
on the outside of the film roll.
Poly-in
Adhesive surface
Poly-out
Adhesive surface
Fig. 6-3. Poly-in and Poly-out Films.
The machine can perform four functions:
•
Decaling (laminating and applying an adhesive
to the back of the item).
•
Mounting, using one film.
•
Mounting, using no film.
•
Roll-to-roll over-lamination.
Page 6-2
Polyester surface
Polyester surface
640t – Installation and Operating Instructions
IMPORTANT: The top and bottom rolls of laminating
film must be the same width.
Always change the top and bottom supply rolls at the
same time.
The film will wrap around the rollers if:
•
One or both rolls of film are allowed to run
completely off its core.
•
Only one roll is used.
•
Different widths of rolls are loaded together.
•
Either roll is loaded with the adhesive side
against a roller.
There are two methods of loading film.
•
Using a threading card.
•
Tacking new film to existing film.
These are described in "Threading Film with a
Threading Card" on page 6-5 and "Loading Film by
Tacking New Film to Existing Film" on page 6-7. Prior
to loading film, the print clamp and feed table need
to be removed.
Advertisement
Table of Contents
