Table of Contents
Advertisement
640t – Installation and Operating Instructions
6. o
peration
This chapter describes how to use the laminator to:
•
Operate the machine
•
Load films (web the machine)
•
Laminate items
•
Mount items
g
o
eneral
peration
These instructions assume that the films have been
loaded. For information about loading films, see
"Loading Film" on page 6-2.
Fig. 6-1. Control Panel.
To run the laminator:
On (I) with the power switch
1.
Turn the laminator
located at the back of the machine.
The Display ("Fig. 6-1. Control Panel.") is:
•
Set at
COLD or 32*
9
•
Speed
•
Ready to run
2.
Set the Roller Pressure Handle for High
Lamination ("Fig. 6-2 Roller Pressure Handle.").
WARNING: Make sure the print clamp and
feed tray are in their proper positions. Your fingers
and hands could be trapped and crushed in the
rollers. Clothing, jewelry, and long hair could be
caught in the rollers and pull you into them.
Fig. 6-2 Roller Pressure Handle.
3.
Set the Roller Pressure Handle for the thickness
of the item that is to be laminated or mounted.
4.
Set the desired speed on the control panel.
RUN or the foot switch.
5.
Press
The rollers will begin to turn.
6.
Position the item or items to be laminated or
mounted on the feed table.
7.
Push the item(s) squarely into the roller nip point
(where the two rollers meet).
Additional items can be laminated or mounted
without stopping and starting the machine.
8.
Release the
foot switch or press STOP to
stop the laminator when all of the items have
completely exited the rear of the machine.
Page 6-1
Advertisement
Table of Contents
