Advertisement
Quick Links
otee!
1
Please note that there can be small differences
between your product and the images in
these instructions.
otee!
1
Please note that during storage and transport,
especially at high ambient temperature, some
of the oil and grease used for assembly may
leak and stain the packaging. This will not cause
damage to the product, wipe off the excessive
oil or grease with a cloth.
Shock absorber for BMW R1200R & R1200RS
BM 511
Mounting Instructions
Kit contents
Description
Shock absorber
Washer Ø8
Tie-rap
Nut M8
Screw M8x50
Sticker "Memo notes"
Sticker "ÖHLINS" wh/tr
Sticker "ÖHLINS" bl/tr
Owner's manual
otee!
1
This product can be used on a vehicle equipped
with Dynamic ESA. However, the Dynamic ESA
front fork will not function correctly when the
Dynamic ESA shock absorber is disconnected.
Therefore, it is recommended to also install an
Öhlins cartridge kit. An error code and a warning
light will appear in any circumstance. Contact an
Öhlins dealer for advice
otee!
1
Before you install this product, check the kit
contents. If anything is missing, please contact
an Öhlins dealer.
⚠
Warninge!
Before you install this product, read the Öhlins
Owner's manual. This product is an important
part of the vehicle and the vehicle stability.
Part
o
Pcs
BM511
1
00153-01
2
00231-01
2
00430-05
1
01046-25
1
01180-01
1
01185-01
2
01185-04
2
07241-02
1
Advertisement
Related Manuals for Öhlins BM 511
Summary of Contents for Öhlins BM 511
- Page 1 This will not cause damage to the product, wipe off the excessive oil or grease with a cloth. Shock absorber for BMW R1200R & R1200RS BM 511 Mounting Instructions...
- Page 2 Mou tI g I StRuctIo S ⚠ Warninge! We strongly recommend to let an Öhlins dealer Loosen the foot rests enough to be able to install this product. slightly raise the rear sub frame. ⚠ Warninge! ✋ cautione! If you work with a lifted vehicle, make sure that it Make sure not to damage/scratch or over is safely supported to prevent it from tipping over.
- Page 3 Mou tI g I StRuctIo S Use the supplied M8x50 screw to install the preload adjuster on the right side silencer bracket, see figure. Tighten the screw. You may need to hold the screw not to untighten it when you tighten the M8 nut. Install the: - foot rests - break fluid reservoir...
- Page 4 aDjuStMe tS ⚠ Warninge! Before you ride/drive, always make sure that the setup is according to the recommended setup data. Read about adjustments and setting up in the Öhlins Owner’s Manual before you make any adjustments. Contact an Öhlins dealer if you Spring have any questions about setting up.