Download Print this page
Öhlins DU 569 Mounting Instructions

Öhlins DU 569 Mounting Instructions

Shock absorber for ducati panigale v2/959/899

Advertisement

Quick Links

Note!
1
Please note that there can be small differences
between your product and the images in
these instructions.
Note!
1
Please note that during storage and transport,
especially at high ambient temperature, some
of the oil and grease used for assembly may
leak and stain the packaging. This will not
cause damage to the product, wipe off the
excessive oil or grease with a cloth.
Shock absorber for Ducati Panigale V2/959/899
DU 569
Mounting Instructions
Note!
1
For Panigale 899: Shorten the shock absorber
5 mm by turning the end eye 5 turns in, before
mounting the shock.
For Panigale 959: Shorten the shock absorber
3 mm by turning the end eye 3 turns in, before
mounting the shock.
Kit Contents
Description
Shock absorber
C-spanner
Sticker Memo notes
Sticker set Öhlins
Owner's manual
Note!
1
Before you install this product, check the kit
contents. If anything is missing, please contact
an Öhlins dealer.
Warning!
Before you install this product, read the Öhlins
Owner's manual. This product is an important
part of the vehicle and the vehicle stability.
Part No
Pcs
DU 569
1
00710-06
2
01180-01
1
1
07242-07
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the DU 569 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Öhlins DU 569

  • Page 1 For Panigale 959: Shorten the shock absorber 3 mm by turning the end eye 3 turns in, before mounting the shock. Kit Contents Description Part No Shock absorber DU 569 C-spanner 00710-06 Sticker Memo notes 01180-01 Sticker set Öhlins Owner’s manual...
  • Page 2 MOUNTING INSTRUCTIONS ⚠ Warning! We strongly recommend to let an Öhlins dealer Install the Öhlins shock absorber in the same install this product. position as the original shock absorber. ⚠ Warning! Note! If you work with a lifted vehicle, make sure that it Lower the vehicle so that the suspension is safely supported to prevent it from tipping over.
  • Page 3 MOUNTING INSTRUCTIONS Carefully lift the rear end of the tank, note Connect the grounding wire and the electric the grounding wire on the left side and make cable, install the cover, bracket and the seat. sure not to squeeze or stretch any cables. ✋...
  • Page 4 ADJUSTMENTS ⚠ Warning! Before you ride/drive, always make sure that the setup is according to the recommended setup data. Read about adjustments and setting up in the Öhlins Owner’s Manual before you make Compression any adjustments. Contact an Öhlins dealer if damping you have any questions about setting up.